Looked online, didn't see anything available, so i decided to work with what I had. I measured the depth of the grooves and got .0005. its not much, but both bushings showed a tendency to wear the hardest on one side. That causes a bit of a shoulder, and I didn't want to risk this damaging the new seals. I have a lathe, but i was afraid that due to the hardness of these parts, that trying to turn this could end up badly. After searching about 5 machine shops near me, one of the machinists i spoke to suggested to use a honing stone with oil.
![Idea :idea:](./images/smilies/icon_idea.gif)
![Exclamation :!:](./images/smilies/icon_exclaim.gif)
![Image](https://i.imgur.com/H02ncxb.jpg)