RZ350 Primary / Clutch Side Cover Modification
Posted: Sat Dec 31, 2011 2:11 pm
Guys,
Over the past few months I have been building the tooling, engineering gaskets, and machining aluminum, to produce RZ350 primary, (right side), covers that have the ability to get to the clutch springs , and more importantly adjust the clutch release rod, without removing the complete primary cover, (2 hours work). Yamaha RZ's are probably the only engines ever produced that do not allow you to get to the clutch adjustment easily. Actually, Yamaha was going to stamp out the cover, but found that the engine would not past noise regs when they did. I did this project after finding Motion-Pro clutch cables that had different inner to outer lengths.
So, I built these for me, however, if anyone else would like one, email me at "image@alexssa.net", and I'll tell you how I can do your side cover. The cost will be $85.00 for anyone on the forum, $95.00 retail.
Brian
http://i1106.photobucket.com/albums/h36 ... G_0256.jpg
http://i1106.photobucket.com/albums/h36 ... G_0249.jpg
http://i1106.photobucket.com/albums/h36 ... G_0270.jpg
http://i1106.photobucket.com/albums/h36 ... G_0244.jpg
http://i1106.photobucket.com/albums/h36 ... G_0224.jpg
http://i1106.photobucket.com/albums/h36 ... G_0226.jpg
http://i1106.photobucket.com/albums/h36 ... G_0242.jpg
Over the past few months I have been building the tooling, engineering gaskets, and machining aluminum, to produce RZ350 primary, (right side), covers that have the ability to get to the clutch springs , and more importantly adjust the clutch release rod, without removing the complete primary cover, (2 hours work). Yamaha RZ's are probably the only engines ever produced that do not allow you to get to the clutch adjustment easily. Actually, Yamaha was going to stamp out the cover, but found that the engine would not past noise regs when they did. I did this project after finding Motion-Pro clutch cables that had different inner to outer lengths.
So, I built these for me, however, if anyone else would like one, email me at "image@alexssa.net", and I'll tell you how I can do your side cover. The cost will be $85.00 for anyone on the forum, $95.00 retail.
Brian
http://i1106.photobucket.com/albums/h36 ... G_0256.jpg
http://i1106.photobucket.com/albums/h36 ... G_0249.jpg
http://i1106.photobucket.com/albums/h36 ... G_0270.jpg
http://i1106.photobucket.com/albums/h36 ... G_0244.jpg
http://i1106.photobucket.com/albums/h36 ... G_0224.jpg
http://i1106.photobucket.com/albums/h36 ... G_0226.jpg
http://i1106.photobucket.com/albums/h36 ... G_0242.jpg