has any one tried the Hinson Clutch kit
I was particular looking at the straight cut gear set with the there hinson basket
I am not using the oil pump ,, I am blanking off
Also have all ready install the two stroke crank shaft and TZ roller bearings .. with the groove cut out on center bearing
or should I make my own gear set......
or do you know where I can get just the straight gear set
thanks
Hinson clutch and straight gear set
Moderator: rztom
Hinson clutch and straight gear set
1964 Austin Cooper S 1071cc
1967 Austin Cooper S vintage race car
1999 Ducati ST 4
1981 RD350LC , R1 Front,toomey pipes, Barnet Clutch, ported , PJ carbs, R1 Speedo 01
1983 RZ 350 - stroker bike,R6 rear shock,tapered stem bearings,progressive springs,
1967 Austin Cooper S vintage race car
1999 Ducati ST 4
1981 RD350LC , R1 Front,toomey pipes, Barnet Clutch, ported , PJ carbs, R1 Speedo 01
1983 RZ 350 - stroker bike,R6 rear shock,tapered stem bearings,progressive springs,
- T.RexRacing
- Posts: 1318
- Joined: Fri Nov 01, 2013 8:34 pm
- Location: back in the hills
Re: Hinson clutch and straight gear set
Cannot speak to the straight cut gears. I run a full Hinson in my '84 RZ350 filled with Barnetts plates/springs. Aside from a manly pull at the lever it's invisible. Cannot tell the difference from OEM. And I guess that's as good an endorsement you could get.
There is only one difference between a madman and me. The madman thinks he is sane. I know I am mad.
Salvador Dali
Salvador Dali
Re: Hinson clutch and straight gear set
The only thing I don't like about the Hinson set up is their choice to use springs.. if anything you want to make the clutch as light as you can.. My choice for the best straight cuts is Liberty Gears. Ed
http://www.erlenbachracing.co" onclick="window.open(this.href);return false;
Re: Hinson clutch and straight gear set
Do you have there contact numberEE wrote:The only thing I don't like about the Hinson set up is their choice to use springs.. if anything you want to make the clutch as light as you can.. My choice for the best straight cuts is Liberty Gears. Ed
Have you used them ?
I have tz roller bearing s so thinking straight cut gears !!
I am running no oil pump
Jim
1964 Austin Cooper S 1071cc
1967 Austin Cooper S vintage race car
1999 Ducati ST 4
1981 RD350LC , R1 Front,toomey pipes, Barnet Clutch, ported , PJ carbs, R1 Speedo 01
1983 RZ 350 - stroker bike,R6 rear shock,tapered stem bearings,progressive springs,
1967 Austin Cooper S vintage race car
1999 Ducati ST 4
1981 RD350LC , R1 Front,toomey pipes, Barnet Clutch, ported , PJ carbs, R1 Speedo 01
1983 RZ 350 - stroker bike,R6 rear shock,tapered stem bearings,progressive springs,