RZ/RD 350 & Misc. 2-Stroke Tech BBS

Did you acquire the Twin Clicker manual? I have a copy if you still need one.

I am looking for a source to have a custom made rear disc rotor made in the US for a rear wheel conversion.
Thanks

Final wiring revision:

Installed

I did the same procedure with the vacuum port with a slightly larger initial drill. View from the venturi: green=vacuum port, red=oil injection port IMG_7751.jpg Also installed a Thunder Products IntelaJet. The two cables on the right are for the cable actuated choke. IMG_7755.jpg A test fit: IMG_77...

Working on the new carb setup for the RZ. Authentic Mikuni VM30 from Sudco. Modifying for oil injection ports and a vacuum port for the fuel petcock. IMG_7750.jpg I initially drilled the oil injection port with a 1mm drill bit, then short drilled with the #21 bit. I modified a 10/32 bottoming tap to...

Installed my pipes today.

Engine is installed

A few more engine shots

Assemble the engine

A few port images. Ed Toomey Designs

.

Been working to finish up the RZ lately. I had sent the cylinders, head, top engine case, crank and gears to Ed Toomey Designs for a Stage 2 port, pump gas squish and gear undercut. Also purchased his ETD Programmable CDI package. Built the engine, installed into the frame and have just finished mod...

https://lh3.googleusercontent.com/Vk_OYxy3MlyMGdvwvPtRGI3pmRQdINHx-DFx8r_7mSsQJ-eV1A6h7ehXXgSzx5InKEGyf574otOgW76in5-F09BcSB_cyG_ww35Ap_4iKiI-U5WhNiDqKMWxa8Te9na6LwAQqRAwysDNr6_9BHBLqTIxnu51KM6dBUK4bguKg_as80OfoK5SqsuQJG63S6orkRLVT5lvvIyRAOZTQ-KhaPdnaweZma46kzDW78adMw7RVO11htixO46uHldr_YFtkGZV173zE...