500 Two-Stroke Tech

Anyone successfully stiffened up their standard front fork set up.? I rode mine for the first time since a full resto to have it MOT'd and the front felt way too soft and felt like it would bottom out if pushed hard. I rebuilt them with 5w fork oil, was wondering if a new modern set of progressive s...

Anyone got a spare clutch side engine case they want to sell?

Bit of a long shot but would any of you have
90460-42261 ( Rd500lc carb clips)
Thanks

Anyone got these off EBay?? If so are they any good?

Anyone in the UK used Firefox Racing
for their crank rebuild service?
If so are they recommended?
Thanks

Anyone got NOS of part #23
The blanking seal for the crank
Part number 90338-47102

Can anyone offer their thoughts on the make of piston use on a rebuild?
Which are the best to use?

Someone has suggested soldering the top two
Holes in the banjo to close off the anti dives
Anyone done this? Replacing the banjo with
A bolt at the anti dive unit seems the best solution

Can anyone recommend a replacement radiator?
The one on mine has corroded as it appears previous
Owners only used tap water as coolant!!
As a result, corrosion and holes that make it beyond repair
There are several asvertised on Ebay... but any experience
Of them?
Thanks

Can anyone provide a step by step ( ideally with pictures)
On stripping down the front forks?
Thanks

Has anyone removed the anti dive units
And replaced them with the blanked off plates that
are available?
Does it make much difference?

Does anyone have the adjustment knob and plastic
collar with the red ring on it for the anti dive unit?
One of my units has been broken off or something
By previous owners
Any help appreciated
Thanks

Can anyone help with NOS or very very good condition
Discs please? Especially need a rear disc which
I believe is very difficult to find!!

Also does anyone know if the discs were also used
On other models ? I know FZ750 had some common bits
Any help appreciated

great advice re the car trim !! thanks people!!

Does anyone have item # 35 #43 and #44 in the schematic?
The trim that goes along the lower tank edge?
Thanks